Truck Bed or Exterior Textured Application

Click to Print This Page

Truck Bed or Exterior Textured application
(if uncoated- refer to Bare Metal guidelines)


-2 stipple roller sleeves per gallon (Included with purchase of gallon)

-80 grit Sandpaper

-Xylene (Xylol) OR Solvide

-Stir stick or electric paint mixer

-Roller Tray

-Cloth or sturdy cotton rag

-Paint Gloves

-Household non-chlorinated detergent, like Spic n Span

-3M Blue tape (Optional)

-Paint Respirator (Optional)

Surface Prep

-Clean the surface thoroughly, with a non-chlorinated household detergent

-Rough up the surface with 80 grit sandpaper

-Wipe down the surface with xylene or Solvide on a cloth and once completely dry, apply the Durabak.


Application Process

-Do not open can until surface is prepped and ready to go. 

-Then open can and stir well so that the rubber granules are suspended inside.

-Pour a portion into a roller tray and begin application.

-Roll on first coat using Durabak stipple roller sleeve.

-Use a paint brush in corners and hard to reach areas. 

-Stir occasionally while working with the product. 

-Keep lid on can while not in use.



1 gallon of textured Durabak covers roughly 60 square feet in our standard 2 coat application.

Good to Know

-Durabak begins to cure with exposure to air, so minimize exposure to air while working with it.

-The consistency of the Durabak should be runny, as it’s self leveling. If it’s thicker, you can add up to 15% xylene to thin it. It should be mixable after adding the xylene and back to a runny form. If it’s pasty and thick, DO NOT APPLY, rather reach out to us for assistance.

-You will have a few hours of work time once the can is opened (3 to 5 hours normally).
-A second coat can be applied using a stipple roller sleeve after 1-2 hours, once the first coat is touch dry.

-After second coat is applied allow 24 hours before walking on it.  Complete cure is about 5 or 6 days, so no heavy use until then.

Additional Tips

-Temp should ideally be 60 degrees or above for the application, and above 40% humidity.

-Xylene should be applied immediately to clean up any misapplied Durabak.

-If taping off, use 3M Blue tape and remove immediately after second coat is applied at taped off edges, then continue with general application of the second coat.