Aluminum Boat application
– Bare Aluminum
-2 stipple roller sleeves per gallon (Included with purchase of textured gallon) or short nap roller, like a 3/16” mohair or similar for a smooth application.
-40 grit Sandpaper
-Stir stick or electric paint mixer
-Cloth or sturdy cotton rag
-Household non-chlorinated detergent, like Spic n Span
-3M Blue tape (Optional)
-Paint Respirator (Optional)
-Clean the surface thoroughly, with a non-chlorinated household detergent
-Rough up the surface with 40 grit sandpaper
-Clean and apply a self etching primer, like Zinc Chromate, or any other metal self etch primer that’s compatible with Polyurethane or the Durabak primer- Metcote.
-DO NOT USE XYLENE or SOLVIDE
-Do not open can until surface is prepped and ready to go.
-Then open can and stir well.
-Pour a portion into a roller tray and begin application.
-Roll on first coat of textured using Durabak stipple roller sleeve or a short nap for smooth Durabak.
-Use a paint brush in corners and hard to reach areas.
-Stir occasionally while working with the product.
-Keep lid on can while not in use.
1 gallon of smooth Durabak covers roughly 75-80 square feet in our standard 2 coat application.
1 gallon of textured Durabak covers approximately 60 square feet in our standard 2 coat application.
Good to Know
-Durabak begins to cure with exposure to air, so minimize exposure to air while working with it.
-The consistency of the Durabak should be runny, as it’s self leveling. If it’s thicker, you can add up to 15% xylene to thin it. It should be mixable after adding the xylene and back to a runny form. If it’s pasty and thick, DO NOT APPLY, rather reach out to us for assistance.
-You will have a few hours of work time once the can is opened (3 to 5 hours normally).
-A second coat can be applied with the same roller after 1-2 hours, once the first coat is touch dry.
-After second coat is applied allow 24 hours before walking on it. Complete cure is about 5 or 6 days, so no heavy use until then.
-Temp should ideally be 60 degrees or above for the application, and above 40% humidity.
-Xylene should be applied immediately to clean up any misapplied Durabak.
-If taping off, use 3M Blue tape and remove immediately after second coat is applied at taped off edges, then continue with general application of the second coat.
-If there’s old carpet glue, no specific solvents are required to remove it, as roughing up with 40 grit, will remove most of the glue. Trace amounts of glue residue will normally not inhibit Durabak bonding to the properly prepped aluminum.
- Truck Bed or Exterior Textured application
- Truck Exterior Smooth Application
- Fiberglass boat application
- Aluminum boat application
- Aluminum Boat application – Painted
- Aluminum Boat application – Bare or Carpet Removed
- Wood application
- Bare Metal Application
- Concrete application
- Plastic Application
- Bumper, Fender Flares application
- Rubber application
- Epoxy surface application
- Durabak Reapplication
- Durabak Adhesion Test